Adding custom patches on a group’s backpacks or bags promotes pride in involvement and a sense of belonging. Personalized custom iron-on patches are also a cost-effective option to enhance the appearance of your team. Request a free quote from American Patch right now to create custom patches with no minimum order that you will adore. Any worries about iron-on patches coming loose can be resolved with ease. With proper application and upkeep, custom iron-on patches can be prevented from flaking off.
How to Stop Iron-On Patches From Scratching
- Cover the counter or ironing board with a towel.
- Use a thin cloth similar to a handkerchief.
- Set a timer.
- Have fusible web, a needle, and thread on hand.
Select Superior Iron-On Patches
You start along the path to success with a quality patch from a specialty manufacturer like American Patch. In the near future, inexpensive custom velcro patches with peel-and-stick glue will come off. Therefore, you should choose custom iron-on patches that are affixed using heat-activated adhesive.
The Best Ways to Stop Iron-On Patches from Coming Off
- Clean the surface where the custom patch will be applied. You can either hand wash the area on a backpack or wash the item in the washing machine. Washing is necessary to get rid of any factory-left finish on the material.
- Allow the material to air dry.
- Ensure the surface is as flat as possible before applying the patch. Spread it evenly on a towel-covered counter or ironing board.
- Heat up your iron and iron the area flat to remove all creases.
- Place an iron-on patch directly onto the fabric.
- Put a small towel over it.
- Verify that your iron is free of water and switch off the steam setting.
- Heat the iron at the temperature that the patch manufacturer recommends, usually the highest setting.
- Firmly press the iron down on the cloth-protected spot for 15 seconds.
- Apply constant pressure on the patch and cloth for three more minutes.
- Turn the bag inside out and heat the patched area from the back.
- Apply heat and hard pressure from the back for three more minutes.
Before testing the borders of the patch, allow it to cool. If it seems loose, attempt heating it once again. Washing the item as required will lessen the strain on the patch adhesive in the future. Allow the garment to air dry after washing it, as the heat from the dryer will weaken the patch’s adhesive.
How Should I Proceed If an Iron-On Patch Comes Off?
The forces of time can sometimes overcome strategies for keeping custom iron-on patches from coming off. A custom patch may eventually come loose. Just tack it in place with a few stitches at the corners if you manage to catch it before it slips off. Additionally, you can use fusible web to refresh an iron-on patch.
You can purchase this heat-activated adhesive fabric at the sewing supplies store:
- Cut a piece of fusible web to match the patch’s size.
- Clean and dry the surface.
- Place the fusible web between the patch and the material.
- Apply heat with an iron.
